EOS EMOTEC B6000 Uživatelská příručka stáhnout pdf (Strana 14)

14 GB

17:10

P 1

20:03

17:10

You are now familiar with the program

parameters needed for a sauna bath.

With this sauna control unit you may also

personalize the settings for your sauna

system.

Once you have chosen these settings, they

will be applied after every restart.

These settings are altered on the "F"-level,

i.e. "F" appears for each corresponding

function selection on the display.

Using the selection buttons and you

can now set heating time.

Please consider, though, that the cabin

needs 40-50 minutes for warming up, to

create a pleasant climate in the cabin. For

example, if you wish to take your sauna

bath at 6 p.m., then you should set the

startup time to 5:10 p.m.

Confirm the selected time by holding the

"MODE" button. P1 briefly appears on the

display.

As long as P1 is shown on the display,

press the

button to start the delayed

start-up sequence.

After a short time, the display alternates

between current time and startup time. The

display illumination goes out.

When the pre-selected start-up time is

reached, the sauna switches itself on.

After the designated heating time it then

shuts itself back off automatically.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Komentáře k této Příručce

Žádné komentáře